Filter
Top Products
set udpserial
Chapter 2 Command Descriptions 217
Options Options for setting general UDP serial forwarding characteristics
port=range
Used to specify the serial port. Optional on a single-port device.
state={on|off}
Used to enable or disable sending data from the serial port to remote
network destinations. The default is “off.”
sendcount=bytes
The number of bytes received from the serial port that will cause the data
to be sent on to the network destinations. This trigger cannot be disabled.
The default is 1024 bytes.
sendtime={0|time}
The amount of idle time, in milliseconds, allowed before sending data to
the network. If no data is received on the serial port for the time specified
by this option, any buffered data will be sent on to the network
destinations. A value of 0 (zero) disables this trigger.
endpattern=string
If this string is set, any pattern match of data received from the serial port
will cause the data to be sent on to the network destinations. The
maximum length of this string is 16 characters, including escape
sequences for special characters. For more details on the escape
sequences, see "Entering Special Characters in String Values" on page
13. The maximum parsed length of this string is 4 characters. That is, this
string must reduce down to a 4-character string when the escape
sequences are processed.
strippattern={on|off}
Determines how the data specified by the “endpattern” option is handled.
on
The endpattern that is found is stripped from the stream before any
data is to be sent on to the network destinations.
off
The endpattern is not stripped from the stream before data is sent on
to network destinations.
The default is “off.”