Filter
Top Products
set term
Chapter 2 Command Descriptions 215
set term
Devices
supported
This command is supported in all Digi Connect products except
ConnectPort Display.
Purpose Allows for connecting a terminal to a device’s serial port and accessing the
command line of the device.
In the cases where the default access to the terminal and the command
line is “on,” this command is important if users want to use the serial port
for purposes other than having a command line. That is, they must change
the state of the serial port access from “on” to “off” in order to use the serial
port for another purpose.
Required
permissions
For Digi Connect products with two or more users, permissions must be set
to “set permissions s-term=read” to display terminal settings, and
“set permissions s-term=rw” to display and change terminal settings.
Syntax Configure terminal settings
set term [state={on|off}]
Display current terminal settings
set term
Options state={on|off}
Specifies whether terminal access is enabled for the serial port. The
default is “on” for Digi Connect WAN and Digi Connect RG devices.
Examples #> set term
Serial Terminal Configuration :
port# state
1 on
2 on
See also • "revert" on page 61.
• "show" on page 249.