Filter
Top Products
set permissions
Chapter 2 Command Descriptions 157
set permissions
Devices
supported
This command is supported in all Digi Connect Family devices. However,
the extent of its use varies according to the user model implemented in the
Digi Connect product. For Digi Connect products with one or two users, this
command does not apply. It does apply to Digi products with two or more
users. See "User Models and User Permissions in Digi Connect Products"
on page 14 for more information.
Use of command options also depends on the features implemented in Digi
devices. For example, “s-ethernet” is only supported in the wired devices.
Purpose Used to set user permissions associated with various services and
command-line interface (CLI) commands, or display current permission
settings.
Commands without permissions
There are no permissions associated with the following commands:
•close
• exit
• help
•info
• quit
Permissions for the “revert” command
For the “revert” command, the permissions associated with the various
“set” commands are used, except for the “revert all” command variant,
which uses a different mechanism that bypasses the individual “set”
commands.
Permission descriptions
Required
permissions
For Digi Connect products with two or more users, permissions must be set
to “set permissions s-permissions=read” to display permissions, and
“set permissions s-permissions=rw” to display and change permissions.
When permissions are set to “set permissions s-permissions=rw,” a user
cannot set another user’s permission level higher than their own level, nor
can they raise their own permission level.