Filter
Top Products
info
Chapter 2 Command Descriptions 41
info
Devices
supported
This command is supported in all Digi Connect products.
Purpose Displays statistical information about a device.
The “info” command displays statistical information about a device over
time. In contrast, the “display” command’s focus is on real-time information,
while the “status” command displays the status of outgoing connections
(connections made by “connect,” “rlogin,” or “telnet” commands).
Command options allow display of the following categories of statistics:
• Device statistics
• Ethernet statistics
• ICMP statistics
• IP statistics
• Mesh network statistics
• Serial statistics
• TCP statistics
• UDP statistics
• WLAN statistics (for wireless devices only)
The statistics in these tables are those gathered since the tables were last
cleared. The statistics tables are cleared by rebooting the Digi device.
Status and statistics for mobile communications
To display information and statistics for mobile/cellular communications,
issue a “display mobile” command. To display SureLink statistics, issue a
“display pppstats” command. See "display" on page 27.
Syntax info {device|ethernet|icmp|ip|mesh|serial|tcp|udp|wlan}
Options For a description of the statistics displayed by all these options, see
“Results” on the following page.
device
Displays statistics from the device table. This information includes
device-model information, MAC address, current Boot and POST code,
firmware, memory usage, utilization, and uptime. The information
displayed by this option is the same as that displayed by the
“display device” command (see "display" on page 27).
ethernet
Displays statistics from the Ethernet table.
icmp
Displays statistics from the ICMP table.
ip
Displays statistics from the IP table.