Filter
Top Products
set autoconnect
82 Chapter 2 Command Descriptions
Options port=range
Used to specify the serial port. Optional on a single-port device.
state={on|off}
Enables or disables the autoconnect feature.
on
Enables the autoconnect feature.
off
Disables the autoconnect feature.
The default is off.
If you are using the serial port for another purpose, it is recommended
this value be set to “off.”
trigger={always|data|dcd|dsr|string}
Indicates which events from the serial port will trigger a network
connection to occur.
always
The serial port will continually attempt to keep a connection to a
remote network destination active.
data
The serial port will attempt a network connection whenever data
arrives on the serial port.
dcd
The serial port will attempt a network connection whenever the serial
port’s DCD signal goes high.
dsr
The serial port will attempt a network connection whenever the serial
port’s DSR signal goes high.
string
A connection will be made upon detecting a particular sting, specified
by the “connect_on_string” option, in the data from the serial port.
The default is “always.”
service={raw|rlogin|ssl|telnet}
The type of network connection that will be established.
raw
A connection without any special processing will occur.
rlogin
A remote login (rlogin) connection will occur.
ssl
A secure connection conforming to SSL (Secure Sockets Layer) Version
3 and Transport Layer Security (TLS) Version 1 will occur.
telnet
A connection with Telnet processing will occur.
The default is “raw.”