Filter
Top Products
Quick Reference for Configuring Features
8 Chapter 1 Introduction
Quick Reference for Configuring Features
The following table shows common features that can be configured from
the command line, and the commands used to configure each feature. If
you are viewing the PDF file of this document, click the commands in the
“Commands” column to go to the command descriptions.
Feature/Task Commands
Alarms "set alarm" on page 70.
Autoconnection (automatically connect a user to
a server or network device)
"set autoconnect" on page 81.
"set serial" on page 189.
"set tcpserial" on page 212.
Bisynchronous communications "set bsc" on page 85
Configuration management/administration Backup/restore a configuration from a TFTP server on the
network: "backup" on page 18.
Update firmware: "boot" on page 19.
Reset configuration to factory defaults: "revert" on page
61; or boot action=factory (see "boot" on page 19).
Reboot the device: "boot" on page 19.
Connectware Manager/Remote Management:
Connectware Device Protocol configuration
settings
"set mgmtconnection" on page 137.
"set mgmtglobal" on page 140.
"set mgmtnetwork" on page 143.
Custom menus "set menu" on page 132.
DHCP (Dynamic Host Configuration Protocol) To configure a DHCP server: "set dhcpserver" on page 96.
To manage and show status of a DHCP server:
"dhcpserver" on page 23.
Display current configuration settings in a device "show" on page 249.
Dynamic DNS (DDNS) "set ddns" on page 92.
Ekahau Client™ device-location software "set ekahau" on page 104
Ethernet settings for wired devices "set ethernet" on page 107.
General Purpose Input/Output (GPIO) pins "set gpio" on page 113.
"set alarm" on page 70.
Help on device commands "help and ?" on page 40.
Host name for a device (Specify a name for the
device)
"set host" on page 118.
Industrial Automation (IA) • “set profile profile=ia” See "set profile" on page 172.
• "set ia" on page 119.
• For additional information on configuring Industrial
Automation, see this web site:
http://www.digi.com/support/ia
IP address settings "set network" on page 149.