set switches
210 Chapter 2 Command Descriptions
Examples Configure standard EIA-232 communication
#> set switches port=1 mode=232
Configure a half-duplex EIA-485 endpoint
#> set switches port=1 mode=485 wires=two termination=on
Configure a full-duplex 422 interior node
#> set switches port=1 mode=485 wires=four termination=off
See also • "display" on page 27. The “display switches” command displays the
current switch settings.
• "revert" on page 61. The “revert switches” command reverts the
“set switches” configuration.