Filter
Top Products
Performing Advanced Access Point Management 113
6 Managing and Maintaining D-Link Access Points
Management > Advanced page. From the Advanced page, you can also manually change the
RF channel and power for each radio on an AP.
Figure 54. Advanced AP Management
Each AP managed by the D-Link WLAN Controller Switch is listed by its MAC address and
location. The location is based on the value in the RADIUS or local Valid AP database.
Table 21 describes the Advanced features you can configure for the AP.
Enabling AP Debugging
You can enable debugging on an AP to allow Telnet access to the access point. Once you
Telnet to the AP, you can issue commands from the CLI to help you troubleshoot.
Table 21. Advanced AP Management
Field Description
Debug To help you troubleshoot, you can enable Telnet access to the AP so that you
can debug the device from the CLI.
The Debug field shows the debug status and can be one of the following:
• Disabled
• Set Requested
•Set in Progress
•Enabled
To change the status, click the Debug status link. The Managed AP Debug
page appears. Table 22 describes the fields on the new page.
Channel Click the Channel link to access the Managed AP Channel/Power Adjust
page. From that page, you can set a new channel for Radio 1 or Radio 2. The
available channels depend on the radio mode and country in which the APs
operate. Table 23 describes the fields on the new page.
Power Click the Power link to access the Managed AP Channel/Power Adjust page.
From that page, you can set a new power level for the AP. Table 23 describes
the fields on the new page.