Filter
Top Products
114 © 2001- 2006 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
D-Link Unified Access System User Manual
The fields in Table 22 appear when you click the Debug link for a managed AP on the
Managed AP Advanced page.
Adjusting the Channel and Power
Changes you make to the channel and power are runtime changes only. If you change the
channel or power settings, the new settings are lost if the AP or switch is reset.
The fields in Table 23 appear when you click the current channel or power setting for an AP
on the Managed AP Advanced page.
Table 22. AP Debug
Field Description
MAC Address Shows the MAC address of the access point.
Location Shows the location of the access point, as configured in the Valid AP data-
base.
IP Address Shows the IP address of the AP.
Status Shows the debug status, which can be one of the following:
• None—Debugging has not been enabled or disabled.
• Set Requested—A request has been made to change the debug status.
• Set Complete—Debugging has been enabled or disabled.
Password Enter the admin password for the AP (the default is admin).
Confirm Password Since the password is encrypted, you must retype the password to confirm
the password.
Enable Debug Select or clear the Enable check box to enable or disable debugging.
Once once you Telnet to the AP, you get an AP interface login prompt. The
user name is admin. Enter the password you set in the previous field. The
default password is admin if you did not specify a new password. From the
AP CLI, you can also access the standard Linux prompt by typing the '!' char-
acter.
You can issue the following debug commands at the Linux OS prompt:
•
get management—Display management interface information
•
get managed-ap—Display managed AP information
You can issue the following debug commands at the Linux OS prompt:
•
ifconfig—display all interfaces.
•
cat /proc/meminfo—View memory utilization
Table 23. Managed AP Channel/Power Adjust
Field Description
AP MAC Address Shows the MAC address of the access point.
Radio Displays the radio and its mode. The changes apply only to this radio.
Channel Status The status is one of the following:
• None
• Set Requested
• Set Complete