Filter
Top Products
54 © 2001- 2006 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
D-Link Unified Access System User Manual
need to change the country code, you can view the list of available countries and their two-
letter codes with the
show wireless country-code command.
The CLI commands to set the country code and enable the WLAN switch are available in
Wireless Config mode. To set the country code, enter
country-code <code>. To enable the
WLAN switch, enter
enable. The following example shows how to access Wireless Config
mode, set the country code to Canada, and enable the WLAN switch.
(switch-prompt) #configure
(switch-prompt) (Config)#wireless
(switch-prompt) (Config-wireless)#country-code CA
(switch-prompt) (Config-wireless)#enable
Preparing the Access Points
Depending on your network security requirements, you might need to connect to the access
point CLI and configure some settings before you connect it to the network. By default, the AP
uses untagged VLANs and no security. If your network requires IEEE 802.1x authentication,
you must configure the supplicant information in the AP before you connect to the network.
Also, if you configure the D-Link WLAN Controller Switch to require local AP
authentication, you must connect to the access point CLI and configure a pass phrase. To
prevent wireless clients from having access to the AP management interface, you can create a
management VLAN.
NOTE:The commands you enter on the AP apply the changes to the running
configuration but does not save them to non-volatile memory (NVRAM). To
make the changes permanent so they persist across a reboot, use the
save-
running command.
Logging on to the AP
You can access the AP CLI only through Telnet. The default IP address is 10.90.90.91/8, and
DHCP is enabled by default on the D-Link Access Point. When you connect the AP to a
network with a DHCP server, the AP automatically acquires an IP address. If there is no
DHCP server on the network, the AP retains its default IP address of 10.90.90.91/8 until you
assign a static IP address.
For initial configuration with a direct Ethernet connection, make sure your PC has an IP
address in the 10.0.0.0/8 subnet so you can access the AP CLI.