Filter
Top Products
62 © 2001- 2006 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
D-Link Unified Access System User Manual
3. Change to Interface Config mode for loopback interface 0, and assign an IP address and
subnet mask.
(switch-prompt) (Config)#interface loopback 0
(switch-prompt) (Interface loopback 0)#ip address 10.1.1.1 255.255.0.0
4. [Optional] Change to Interface Config mode for slot 0, port 2, assign an IP address, and
enable routing on the interface.
(switch-prompt) (Config)#interface 0/2
(switch-prompt) (Interface 0/2)#ip address 192.168.1.24 255.255.255.0
(switch-prompt) (Interface 0/2)#routing
You can also use the Web interface or SNMP to enable routing and configure an IP address.
The following shows the procedures to enable routing and configure an IP address on the
switch by using the Web interface.
NOTE:Routing is available under the LAN tab on the navigation menu.
1. Log on to the Web interface and click L3 Features > IP > Configuration to access the IP
Configuration page.
2. From the Routing Mode drop-down menu, choose Enable, and then click Submit.
3. To create a loopback interface, click Routing > Loopback > Configuration.
4. From the Loopback drop-down menu, choose Create, and then click Submit
5. Enter an IPv4 address and subnet mask in the appropriate fields, and then click Submit.
6. To create a routing interface and assign an IP address, click Routing > IP > Interface
Configuration, and select the interface to configure from the Slot/Port drop-down menu.
7. Enter an IP address and subnet mask in the appropriate fields, choose Enable from the
Routing Mode drop-down menu, and click Submit.