Filter
Top Products
192 © 2001- 2006 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
D-Link Unified Access System User Manual
3. From the L3 Features > IP > Interface Configuration page, assign an IP address and
subnet mask to the interface, and make sure routing is enabled.
4. From the Monitoring > L3 Status > VLAN Routing Summary page, view the summary
information for the VLAN routing interface.
Configuring the L3 Tunnel Network
Configure L3 tunneling by modifying or adding a Network. Then, make sure the network is
associated with a VAP on the AP Profile assigned to the APs that wireless clients might use
for roaming. Once you change the AP Profile, re-apply the profile to the APs to reset the APs
that use the profile.
NOTE: When L3 tunneling is enabled, the VLAN ID for the network is not used. In
fact, the switch puts the management VLAN ID, if any, on the tunneled pack-
ets.
In this example, the L3 Tunnel network is on Network 3 on the Default AP Profile. The SSID
of the network is “L3 Tunnel,” and the security mechanism is WPA Enterprise.