Filter
Top Products
Control Codes
100-88002 Rev B Page 157
Bit On/Off Hexadecimal Decimal Function
0 Off 00H <0> Paper roll near-end sensor disabled
On 01H <1> Paper roll near-end sensor enabled
1 Off 00H <0> Paper roll near-end sensor disabled
On 02H <2> Paper roll near-end sensor enabled
2 Off 00H <0> Paper roll end sensor disabled
On 04H <4> Paper roll end sensor enabled
3 Off 00H <0> Paper roll end sensor disabled
On 08H <8> Paper roll end sensor enabled
4-7 - - - Undefined
Table 8 Paper Sensor Commands
[ESC] ~z User Control of Bezel
ASCII [ESC] ~ z <n>
Hexadecimal 1BH 7EH 7AH <n>
Decimal <27> <126> <122> <n>
IPCL %&BF
EPOS none
Description The [ESC] ~z <n> command sets a flash code into the bezel lamp control
logic. This code will override any current flash code and will be overridden by any
internally generated flash code.
Flash codes <n>:
Return Bezel Light to normal state.
Flash 1 time and pause
Flash 2 times and pause
…
8 Flash 8 times and pause
9 Fast steady blink
10 Slow steady blink
11 Active state
Note: The bezel logic may be set to default on or off for the inactive state. If set to be
on by default, the flash will blink off.