Filter
Top Products
Control Codes
100-88002 Rev B Page 83
[ESC] B Set vertical tab stops
ASCII [ESC] B <n
1
> <n
2
> <n
3
> ... <n
i
> 0
Hexadecimal 1BH 42H <n
1
> <n
2
> <n
3
> ... <n
i
> 00H
Decimal <27> <66> <n
1
> <n
2
> <n
3
> ... <n
i
> <0>
IPCL none
EPOS [ESC] B <n
1
> <n
2
> <n
3
> ... <n
i
> 0
Description The [ESC] B <n
1
> <n
2
> <n
3
> ... <n
i
> 0 command sets tab stops at line
positions specified by <n>. The end of the setting is specified by a <0>. All
previously set tabs will be cleared. If n
n
is less than n
n-1
, then the command is in error,
and all of the following information is printed. In other words, tab stops must be
entered sequentially in order to be accepted. A total of 64 tab stops can be specified.
(The power on default is a vertical tab on every line).
[ESC] R Reset horizontal and vertical tab stops
ASCII [ESC] R
Hexadecimal 1BH 52H
Decimal <27> <82>
IPCL &%HV
EPOS none
Description The [ESC] R command resets horizontal and vertical tab stops to power
up configuration. The power up horizontal default is every eight spaces, i.e., 9, 17,
25, etc. The vertical default is every line.
[FF] Form feed
ASCII [FF]
Hexadecimal 0CH
Decimal <12>
IPCL &%FF
EPOS none
Description The [FF] command performs a form feed to the top of the form.
Note: The form feed command can be disabled by setting the form length to zero.
Note: In page mode this command ends page mode. It does not position the paper to
top of form.