Filter
Top Products
Operational Procedures
100-88002 Rev B Page 27
The Diagnostics/Config button
The printer has a configuration and diagnostics button on the right side of the printer,
labeled CONFIG.
Figure 5. Location of Diagnostics/Config Button.
The Diagnostics/Config button is a multifunction button. By pressing and releasing
the Diagnostics/Config button, the printer will enter self test mode. This is intended to
verify the printer’s operation.
By pressing and holding the Diagnostics/Config button for a longer time, two
additional features may be activated. Pressing and holding the button for about two
seconds will enter hex dump mode. Holding the button for about 4 seconds will enter
configuration mode.
To aid in selecting the correct mode, the Fault LED will illuminate as soon as the
button is pressed and indicates that self test is selected. After about 2 seconds the
Fault LED will go out and the PAPER indicator will illuminate. This indicates that hex-
dump mode is selected. After about 4 seconds, the Cover LED will illuminate
indicating configuration mode is selected
Dia
g
nostics/Confi
g
Button
FEED Button