Filter
Top Products
When the Indicators Provide No Help - 99
■
■■
■ When the Indicators Provide No Help
Refer to each relevant item if the following situations arise but the indicators provide no help.
· The image is not projected page 99
· No sound page 106
· The image is unclear page 103
· The remote control will not work page 106
· The image is cut up (Large)/Small page 104
· Cannot end page 107
· The image color is bad page 105
· The image is dark page 105
The image is not projected
● Nothing is displayed
Nothing is displayed
●
Is the Lens Cover still in place?
see page 35
●
Has the power been switched off and then on immediately?
The [Power] button will not operate after projection has been
finished (during the cooling down procedure). The [Power] button
will work again after the cooling down process Projection lamp
(cooling operations: the operation indicator is illuminated in orange)
has been completed.
see page 45
●
Is the Sleep Mode set at ON?
When the sleep mode has been set at [ON], the lamp will be
automatically extinguished if no operations occur and no signals are
input for a period of thirty minutes.
see page 67
●
Did you press the [Power] button?
see page 37
●
Has the brightness of the image been correctly adjusted?
see page 65
●
Is the system in the [A/V Mute] mode?
see page 51
Perform the reset procedure.
see page 68
●
Are image signals being input?
No message will be displayed if the [Menu] - [Settings] - [No Signal
Display] parameter is set at OFF. Set this to black or blue to display
the message.
Refer to the relevant items when the message is displayed.
see page 100
●
Are image signals being input?
No message will be displayed when the [Menu] - [Settings] and [No
Signal Display] parameter is set at [OFF]. Set either black or blue to
display the message. Refer to each relevant item when the message
is displayed.
●
Perform the reset procedure.
see page 68