Filter
Top Products
Troubleshooting - 97
Lamp Indicator
Blinking in
Green
Warm-up in
progress
(Not an error)
·Wait for a moment.
·The green lamp will stop blinking and
become illuminated once the warm-up
procedure has been completed.
37
Blinking in Red Internal error Cease operations, remove the Power Plug from
the socket and contact your dealer or nearest
address provided at page 121 and request
repairs.
Extinguished The power is not
switched on
The power is not switched on.
·Check the power cord connection.
·Check the power supply to the socket.
36
Indicator Status Cause Recovery and Status Reference
Page
Illuminated in
red
Time to replace the
lamp.
Replace the lamp with a new one (ELPLP14).
Blinking in Red Lamp error ·Replace with a new lamp (ELPLP14).
·Check to ensure that the lamp or fan are
correctly attached if the lamp has been
replaced. If the lamp or fan are not correctly
attached, the projector will assume the same
status as if the power has not been switched
on.
·If the lamp is broken, take care to avoid injury
and contact your nearest address provided at
page 121 to request repairs (images cannot be
projected unless the lamp is replaced).
111
Blinking in
Orange
Nearing the time
for replacing the
lamp
Prepare a new lamp. It is recommended that
the lamp is replaced as soon as possible, as
there are cases where the time for replacement
is earlier than stated in the conditions of usage.
111
Extinguished (Not an error)
The power has not been switched on or nor-
mal projection is in progress.
Indicator Status Cause Recovery or Status Reference
Page