Filter
Top Products
74 - Inserting the memory card
■ Inserting the memory card
A memory card is required when using the EasyMP functions.
● Memory cards that can be used
The following memory cards which are compatible with the Type II ATA standard can be used.
· Compact flash (a PC card adapter is required during mounting)
· Smart media (a PC card adapter is required during mounting)
· Memory stick (a PC card adapter is required during mounting)
· ATA flash card
· Micro drive (a PC card adapter is required when mounting.)
● Method of insertion
1
Set the memory card in the card adapter.
Refer to the card adapter's instruction manual for details on the direction it should be
inserted.
2
Insert the memory card set in the card adapter into the projector's PCMCIA card slot.
Insert the card firmly to the back, as shown in the illustration.
Point
· The card will not be able to be inserted to the back if it is inserted back to front. Do not
apply excessive force in this case.
· The access lamp for the PCMCIA card slot will change as follows:
Extinguished: Access not achieved or the card has not been inserted.
Illuminated in orange: Access achieved.(Do not remove the memory card while it is being
accessed.)
Illuminated in red: A non-usable card has been inserted.
· FAT12/16 formatted memory cards can be recognized.
· Depending on the manufacturer, there are smart media adapters that are write-protected
and malfunction when an attempt is made to write in them. Ensure that the write-protect
has been released prior to using smart media.
Access lamp
Rear