Filter
Top Products
9
EMP-735 User’s Guide
Before Using the Remote Control
Using the Remote Control and Remote Operating Range
When using the remote control for the first time, pull out the insulating tape that
is protruding from the battery holder. When the insulating tape is pulled out, the
remote control can be used.
The remote control is used in the following way.
Procedure
Point the remote control light-emitting area toward one of the
remote control light-receiving areas on the projector and operate
the remote control buttons.
Tip :
• Do not allow sunlight or light from fluorescent lamps to shine directly onto the
projector's remote control light-receiving areas, otherwise it may interfere with the
reception of signals from the remote control.
• If delays in the responsiveness of the remote control occur or if it does not operate after
it has been used for some time, it probably means that the battery is getting flat. If this
happens, replace the battery with a new one. ( p.86)
• When not using the remote control, place it into the remote control holder at the back of
the projector so that it does not get lost.
Using the Remote Control
Insulating tape
Menu
A/V Mute
E-Zoom
Freeze
S-Video/Video
Color Mode
Page upPage down
Power
ESCAuto
Enter
Comp/Easy MP
Remote control
light-receiving
area (front)
Menu
A/V Mute
E-Zoom
Freeze
S-Video/Video
Color Mode
Computer
Page upPage down
Power
ESCAuto
Enter
Remote control
light-receiving
area (back)
Remote control
light-emitting area