Filter
Top Products
90
EMP-735 User’s Guide
The projector has a built-in counter which keeps track of the lamp operating
time. When the cumulative operating time reaches a certain point, it causes the
replacement warning message to be displayed. Therefore, the counter needs to
be reset after the lamp has been replaced with a new one. You can do this using
the configuration menu.
Use the remote control to carry out the operations for resetting the lamp
operating time.
Tip :
Do not reset the lamp operating time except after the lamp has been replaced, otherwise
the lamp replacement period will not be indicated correctly.
Procedure
1
Connect the power cable, turn on
the projector's power, and then
press the [Menu] button on the
remote control.
The configuration menu will appear.
2
Select "Reset Lamp Timer" from the
"About" menu and then press the
[Enter] button.
3
Select "Yes" and then press the
[Enter] button.
The lamp operating time will then be
reset.
Resetting the Lamp Operating Time
Menu
A/V Mute
E-Zoom
Freeze
Enter
Remote Control
Frequency
Video Source
V ---.--Hz
Reset Lamp Timer
H ---.--kHz
Lamp 1400H
SYNC Mode
SYNC Polarity
------
H ------
Resolution
Refresh Rate 0.0 Hz
0x 0
Computer
Input Signal RGB
Execute
:
:
:
:
:
:
V ------
:
:
:
:
:
Reset Lamp Timer
Execute?
YES
NO
Maintenance