Filter
Top Products
Command Summary for LQ/FX Emulation
The following commands are available in FX mode but not in LQ
mode:
ESC1
7/72-inch line feed
ESC^ select 9-pin graphics mode
ESC I select character code table
The printer commands listed below function in a slightly different
way when used in LQ or FX emulation modes. Also, many of the
commands which control the print position use approximations
because of the different print densities of LQ/FX series printers and
the EPI-4000.
ESC G, ESC E
These commands produce identical bolding effects on the EPI-4000
printer. On an actual LQ series printer, these two commands create
slightly different effects and can be combined to produce darker
characters.
SI, ESC SI
These commands print 10 cpi characters in a 16.66 cpi font, and
12 cpi characters in a 20 cpi font. On an actual LQ/FX series printer,
these command condense the font.
ESC x
This command is normally used to select between draft and LQ
(NLQ) quality printing on an LQ or FX series printer. However, ,this
command has no effect on EPI-4000 print quality, since all
characters print at 300 dpi Letter Quality.
Modes and Commands
B-21