Filter
Top Products
EPSON Stylus Pro GS6000 User’s Guide
Safety Instructions
7
Setting up the printer
Observe the following when setting up the
printer:
❏ Do not block or cover the vents and openings
in the printer.
❏ Use only the type of power source indicated
on the printer’s label.
❏ Use only the power cord that comes with the
printer. Use of another cord may result in fire
or electric shock.
❏ The printer’s power cord is for use with the
printer only. Use with other equipment may
result in fire or electric shock.
❏ Be sure your AC power cord meets the
relevant local safety standard.
❏ Avoid using outlets on the same circuit as
photocopiers or air control systems that
regularly switch on and off.
❏ Avoid electrical outlets controlled by wall
switches or automatic timers.
❏ Keep the entire computer system away from
potential sources of electromagnetic
interference, such as loudspeakers or the base
units of cordless telephones.
❏ Do not use a damaged or frayed power cord.
❏ Do not attempt to service the printer yourself.
❏ Unplug the printer and refer servicing to
qualified service personnel under the
following conditions:
The power cord or plug is damaged; liquid
has entered the printer; the printer has been
dropped or the casing damaged; the printer
does not operate normally or exhibits a
distinct change in performance.
❏ If you plan to use the printer in Germany, the
building installation must be protected by a
10 or 16 amp circuit breaker to provide
adequate short-circuit protection and
over-current protection for the printer.
❏ When connecting the printer to a computer or
other device with a cable, ensure the correct
orientation of the connectors. Each connector
has only one correct orientation. Inserting a
connector in the wrong orientation may
damage both devices connected by the cable.
❏ This device has two power systems. There is a
risk of electric shock unless the two power
cables are unplugged during the
maintenance.
Using the printer
Observe the following when using the printer:
❏ Do not insert objects through the slots in the
printer.
❏ Take care not to spill liquid on the printer.
❏ Do not put your hand inside the printer or
touch the ink cartridges during printing.
❏ Do not use aerosol products that contain
flammable gases inside or around this
product. Doing so may cause fire.
❏ Do not move the print head by hand;
otherwise, you may damage the printer.
❏ Always turn the printer off using the Power
button. When this button is pressed, the
Power light flashes. Do not unplug the printer
or turn off the power to the outlet until the
Power light stops flashing.
❏ Do not store combustible materials on the
platen while performing the heater operation.
It could lead to fire.
❏ Do not spill flammable liquid over the platen.
This could lead to fire.
❏ Do not operate the paper lever during initial
operation. The print head portion may touch
the pressurizing roller portion, and cause a
malfunction.
❏ Do not drop waste ink when replacing the
flushing pad. If waste ink comes into contact
with the grid roller, the surface of the grid
roller will be damaged, and the media feed
function may be affected.