Filter
Top Products
INPUT EFFECTS SPECIAL KEY COMBINATIONS
61
Special Key Combinations
Use the following key combinations while working with the Input Effects menu.
When you are not working at the Input Effects menu, use the following key combinations.
When the Effects LED light is lit, Input Effects are enabled. The MX-4 DV applies the effects
according to the parameter values for each effect.
When you use the
SHIFT+EFFECTS key combination to disable Input Effects, the MX-4 DV turns
off the LED light. It does not change any effects parameter values, but it does prevent the current
Input Effects from being used. Press
SHIFT+EFFECTS again to enable them.
Table 6: Input Effects Mode Key Combinations
KEY COMBINATION RESULT
ARROW keys
Moves cursor (or, highlight) between the different Input Effects.
Numeric Keypad Directly sets the parameter value for the highlighted effect.
EFFECTS or OK
Exits from Input Effects mode.
EFFECTS buttons Moves the cursor directly to that effect – for example, press POS-
TERIZE to highlight that effect: press MOSAIC to highlight that
effect: and so on.
If the selected effect matches the currently highlighted one on the
Input Effects menu, pressing the
EFFECTS button increments the
effect’s parameter value by one.
SHIFT+0 (zero)
Resets all effects to 0 (off) for the selected channel.
Table 7: Main Mode Input Effects Key Combinations
KEY COMBINATION RESULT
SHIFT+EFFECTS button
Increments the parameter value by one for the selected effect and
applies it to the CURRENT source.
SHIFT+EFFECTS
Temporarily disables and re-enables Input Effects from being
sent to Program out. Refer to the following paragraph.