Filter
Top Products
Management Commands Command Reference
7.5.5.2 snmp trap link-status
This command enables link status traps by interface.
Note: This command is valid only when the Link Up/Down Flag is enabled. See ‘snmpserver
enable traps linkmode’ command.
Syntax
snmp trap link-status
no snmp trap link-status
no - This command disables link status traps by interface.
Note: This command is valid only when the Link Up/Down Flag is enabled. (See
‘snmpserver enable traps linkmode’ command.)
Default Setting
Disabled
Command Mode
Interface Config
This command enables link status traps for all interfaces.
Note: This command is valid only when the Link Up/Down Flag is enabled (See ‘snmpserver
enable traps linkmode’ command.)
Syntax
snmp trap link-status all
no snmp trap link-status all
all - All interfaces.
no - This command disables link status traps for all interfaces.
Note: This command is valid only when the Link Up/Down Flag is enabled (see
“snmpserver enable traps linkmode”).