Filter
Top Products
SNTP (Simple Network Time Protocol) Commands Command Reference
7.8 User Account Management Commands
7.8.1 Show Commands
7.8.1.1 show users
This command displays the configured user names and their settings. This command is only
available for users with readwrite privileges. The SNMPv3 fields will only be displayed if SNMP
is available on the system.
Syntax
show users
Default Setting
None
Command Mode
Privileged Exec
Display Message
User Name: The name the user will use to login using the serial port, Telnet or Web. A new
user may be added to the IBP by entering a name in a blank entry. The user name may be
up to eight characters, and is not case sensitive. Two users are included as the factory
default, admin, and guest.
User Access Mode: Shows whether the operator is able to change parameters on the IBP
(Read/Write) or is only able to view them (Read Only). As a factory default, admin has
Read/Write access and guest has Read Only access. There can only be one Read/Write
user and up to five Read Only users.
SNMPv3 AccessMode: This field displays the SNMPv3 Access Mode. If the value is set to
Read- Write, the SNMPv3 user will be able to set and retrieve parameters on the system. If
the value is set to ReadOnly, the SNMPv3 user will only be able to retrieve parameter
information. The SNMPv3 access mode may be different from the CLI and Web access
mode.
SNMPv3 Authentication: This field displays the authentication protocol to be used for the
specified login user.
SNMPv3 Encryption: This field displays the encryption protocol to be used for the specified
login user.
7.8.2 Configuration Commands
7.8.2.1 username