Filter
Top Products
SNTP (Simple Network Time Protocol) Commands Command Reference
Syntax
dot1x re-authenticate <slot/port>
<slot/port> - is the desired interface number.
Default Setting
None
Command Mode
Privileged Exec
7.9.3.10 dot1x timeout
This command sets the value, in seconds, of the timer used by the authenticator state machine
on this port. Depending on the token used and the value (in seconds) passed; various timeout
configurable parameters are set. The following tokens are supported.
reauth-period: Sets the value, in seconds, of the timer used by the authenticator state
machine on this port to determine when re-authentication of the supplicant takes place. The
reauth-period must be a value in the range 1 - 65535.
quiet-period: Sets the value, in seconds, of the timer used by the authenticator state machine
on this port to define periods of time in which it will not attempt to acquire a supplicant. The
quiet-period must be a value in the range 0 - 65535.
tx-period: Sets the value, in seconds, of the timer used by the authenticator state machine on
this port to determine when to send an EAPOL EAP Request/Identity frame to the supplicant.
The quiet-period must be a value in the range 1 - 65535.
supp-timeout: Sets the value, in seconds, of the timer used by the authenticator state
machine on this port to timeout the supplicant. The supp-timeout must be a value in the range 1
- 65535.
server-timeout: Sets the value, in seconds, of the timer used by the authenticator state
machine on this port to timeout the authentication server. The supp-timeout must be a value in
the range 1 - 65535.
Syntax
dot1x timeout {quiet-period | reauth-period | server-timeout | supp-timeout | tx-period}