Filter
Top Products
Overview Web-Based Management Interface
6.2.2.3.8 Copying Running Configuration to Panel Page
Use this menu to copy a start-up configuration file from the running configuration file on IBP.
Configurable Data
File Name - Enter the name you want to give the file being copied. You may enter up to 32
characters. The factory default is blank.
Non-Configurable Data
The last row of the table is used to display information about the progress of the file copy.
The screen will refresh automatically until the file copy completes.
Command Buttons
Copy to File - Send the updated screen to the IBP perform the file copy.
6.2.2.3.9 Defining Ping Function Page
Use this screen to tell the IBP to send a Ping request to a specified IP address. You can use
this to check whether the IBP can communicate with a particular IP station. Once you click the
Submit button, the IBP will send three pings and the results will be displayed below the
configurable data. If a reply to the ping is not received, you will see No Reply Received from
IP xxx.xxx.xxx.xxx, otherwise you will see Reply received from IP xxx.xxx.xxx.xxx : (send
count = 5, receive count = n).
Configurable Data
IP Address - Enter the IP address of the station you want the IBP to ping. The initial value
is blank. The IP Address you enter is not retained across a power cycle.