Filter
Top Products
SNTP (Simple Network Time Protocol) Commands Command Reference
7.9.4.7 radius-server primary
This command is used to configure the primary RADIUS authentication server for this RADIUS
client. The primary server is the one that is used by default for handling RADIUS requests. The
remaining configured servers are only used if the primary server cannot be reached. A
maximum of three servers can be configured on each client. Only one of these servers can be
configured as the primary. If a primary server is already configured prior to this command being
executed, the server specified by the IP address specified used in this command will become
the new primary server. The IP address must match that of a previously configured RADIUS
authentication server.
Syntax
radius-server primary <ipaddr>
<ipaddr> - is a IP address.
Default Setting
None
Command Mode
Global Config
7.9.5 TACACS Configuration Commands
7.9.5.1 tacacs
This command is used to enable /disable the TACACS function.
Syntax
tacacs
no tacacs
no - This command is used to disable the TACACS function.
Default Setting