Filter
Top Products
7-2
Monitoring and Analyzing Switch Operation
Status and Counters Screens
Monitoring and Analyzing
Switch Operation
Status and Counters Screens
This section describes the status and counters screens available through the
switch console interface and/or the web browser interface.
Note You can access all console screens from the web browser interface via Telnet
to the console. See “Configuration Tab” on page 3-24.
Status or Counters Type Interface Purpose Page
General System Information Console Lists switch-level operating information. 7-5
Management Address
Information
Console Lists the MAC address, IP address, and IPX network number for
each VLAN or, if no VLANs are configured, for the switch.
7-6
Module Information Console For each slot, lists the module type (such as 10/100TX) and
description.
7-7
Port Status Overview Browser Shows port utilization and the Alert Log.3-14
Port Status Console/
Browser
Displays the operational status of each port. 7-8
Port Counters Console/
Browser
Summarizes port activity. 7-10
Address Table
(Address Forwarding Table)
Console Lists the MAC addresses of nodes the switch has detected on the
network, with the corresponding switch port.
7-14
Port Address Table Console Lists the MAC addresses that the switch has learned from the
selected port.
7-15
Spanning Tree Information Console Lists Spanning Tree data for the switch and for individual ports. If
VLANs are configured, reports on a per-VLAN basis.
7-17
IP Multicast (IGMP) Status Console Lists IGMP groups, reports, queries, and port on which querier is
located.
7-19
Automatic Broadcast
Control (ABC) Information
Console If VLANs are configured, reports are on a per-VLAN basis. 7-21
Switch Mesh Information Console For meshed ports, describes operating state, MAC address of
adjacent meshed switch, and identity of peer port on adjacent
switch.
7-22
VLAN Information Console For each VLAN configured in the switch, lists 802.1Q VLAN ID and
up/down status.
7-23