Filter
Top Products
114
Changing Your Workstation’s Hardware Configuration
This appendix describes the procedures to change your workstation’s hard-
ware configuration. It presents the information in the following sections:
• Checking the SCSI IDs
• Preparing your workstation
• Installing storage devices
• Removing the main tray assembly
• Replacing the main tray assembly
• Installing additional memory
• Installing an EISA or GSC option board
• Changing your monitor type
The instructions in this chapter assume you are using HP-UX version 9.05 or
later operating system with HP VUE version 3.0 or later interface.
NOTICE: Your workstation shipped with a package of extra disk slides. Keep the
slides in a safe place, you will need them when you add new devices to the
storage tray.
CAUTION: Always wear a properly grounded wrist strap when reconfiguring your
workstation.
Use the following tools to remove or replace hardware parts when changing
your configuration:
• Light-duty flat blade screwdriver with 150 mm (6 in.) blade
• Needlenose pliers
Also, read the ESD Precautions in Appendix A of this guide.