2. Remove two screws (callout 1), disconnect one connector (callout 2), and then remove the pickup
motor (callout 35).
Figure 2-162 Remove the tray-pickup drive assembly (2 of 3)
1
2
3
3. Remove three screws, and then remove the tray-pickup drive assembly.
NOTE: The cams on the main-drive assembly can prevent the tray-pickup drive assembly from
releasing from the product. If you cannot remove the assembly, remove the DC controller and tray
to provide additional space. See
DC controller PCA and tray on page 161. You might also need to
remove the wire guide from the main-drive assembly. See
Figure 2-198 Remove the main-drive
assembly (3 of 6) on page 205.
Figure 2-163 Remove the tray-pickup drive assembly (3 of 3)
ENWW Internal assemblies 179