Filter
Top Products
Item Sub-item Sub-item Sub-item Description
IPSEC KEEP
DISABLE*
Specify the IPSec status on the print server.
KEEP: IPSec status remains the same as
currently configured.
DISABLE: IPSec operation on the print
server is disabled.
802.1X RESET
KEEP*
Specify whether the 802.1X settings on the
print server are reset to the factory defaults.
RESET: The 802.1X settings are reset to the
factory defaults.
KEEP: The current 802.1X settings are
maintained.
RESET SECURITY YES
NO*
Specify whether the current security settings
on the print server will be saved or reset to
factory defaults.
YES: Security settings are reset to factory
defaults.
NO: The current security settings are
maintained.
DIAGNOSTICS EMBEDDED TESTS This menu provides tests to help diagnose
network hardware or TCP/IP network
connection problems.
Embedded tests help to identify whether a
network fault is internal or external to the
product. Use an embedded test to check
hardware and communication paths on the
print server. After you select and enable a test
and set the execution time, you must select
EXECUTE to initiate the test.
Depending on the execution time, a selected
test runs continuously until either the product
is turned off, or an error occurs and a
diagnostic page is printed.
LAN HW TEST YES
NO*
CAUTION: Running this embedded test will
erase your TCP/IP configuration.
This test performs an internal loopback test.
An internal loopback test will send and
receive packets only on the internal network
hardware. There are no external
transmissions on your network.
Select YES to choose this test, or NO to not
choose it.
HTTP TEST YES
NO*
This test checks operation of HTTP by
retrieving predefined pages from the product,
and tests the embedded Web server.
Select YES to choose this test, or NO to not
choose it.
Table 3-13 Embedded Jetdirect menu (continued)
338 Chapter 3 Solve problems ENWW