F output bin full sensor
NOTE: The front-top, rear-top, and right-front covers have been removed for clarity.
1. Lift the flapper on the delivery assembly to move the output-bin full sensor flag.
Figure 3-10 Test the output-bin-full sensor
2. Check the control-panel display for sensor response.
3. If there is no response, remove the right-front cover (see
Right-front cover on page 103) and verify
that the flag is moving. If not, replace the delivery assembly. See
Delivery assembly
on page 145. If the sensor is malfunctioning, replace the sensor.
ENWW Tools for troubleshooting 251