Filter
Top Products
Item Sub-item Sub-item Sub-item Description
REFRESH YES
NO*
When viewing the ping test results, this item
updates the ping test data with current
results. Select YES to update the data, or
NO to maintain the existing data. However, a
refresh automatically occurs when the menu
times out or you manually return to the main
menu.
LINK SPEED AUTO*
10T HALF
10T FULL
100TX HALF
100TX FULL
100TX AUTO
1000T FULL
The link speed and communication mode of
the print server must match the network. The
available settings depend on the product and
installed print server. Select one of the
following link configuration settings:
CAUTION: If you change the link setting,
network communications with the print server
and network product might be lost.
AUTO: The print server uses auto-
negotiation to configure itself with the highest
link speed and communication mode
allowed. If auto-negotiation fails, either
100TX HALF or 10T HALF is set depending
on the detected link speed of the hub/switch
port. (A 1000T half-duplex selection is not
supported.)
10T HALF: 10 Mbps, half-duplex operation.
10T FULL: 10 Mbps, full-duplex operation.
100TX HALF: 100 Mbps, half-duplex
operation.
100TX FULL: 100 Mbps, full-duplex
operation.
100TX AUTO: Limits auto-negotiation to a
maximum link speed of 100 Mbps.
1000T FULL: 1000 Mbps, full-duplex
operation.
Table 3-13 Embedded Jetdirect menu (continued)
ENWW Tools for troubleshooting 341