Filter
Top Products
Description Recommended action
MANUALLY FEED OUTPUT STACK
Then press OK to print second side
The product has printed the first side of a
manual duplex job and is waiting for the user
to insert the output stack to print the second
side.
1. Maintaining the same orientation,
remove document from the output bin.
2. Flip document printed side up.
3. Load document in Tray 1.
4. Press the OK button to print.
MOVING SOLENOID
To exit press
The solenoid is moving as part of a
component test.
No action is necessary.
MOVING SOLENOID AND MOTOR
To exit press
The solenoid and a motor are moving as part
of a component test.
No action is necessary.
No job to cancel You have pressed the stop button but the
product is not actively processing any jobs.
No action is necessary.
NO STORED JOBS Displayed when the user enters the
RETRIEVE JOB menu and there are no jobs
to retrieve.
No action is necessary.
NON HP SUPPLY INSTALLED The product is using a non-HP supply. This
message appears for six seconds after you
install a non-HP supply.
Any product repair required as a result of
using non-HP or unauthorized supplies is not
covered under warranty. HP cannot ensure
the accuracy or the availability of certain
features.
Paused
To return to Ready press
The product is paused, and there are no error
messages pending at the display. The I/O
continues receiving data until memory is full.
Press the stop button .
Performing upgrade
<X:YYY> % complete
Do not power off
The product is in the process of upgrading the
firmware.
Please wait until the upgrade is complete.
Performing... COLOR BAND TEST The color-band test is being performed. No action is necessary.
Performing... PAPER PATH TEST The product is performing a paper path test. No action is necessary.
Please wait The product is in the process of clearing data. No action is necessary.
Powering off... The product is shutting down. Please wait until the product shuts down.
Printing <REPORT> The product is printing an internal page. The
product will return to the online Ready state
when the page is completed.
No action is necessary.
PRINTING STOPPED
To continue press OK
Time has expired on the Print/Stop test. Press the OK button to continue.
Printing...ENGINE TEST The product is printing an engine test page. No action necessary.
Processing duplex job
Do not grab paper until job completes
Paper temporarily comes into the output bin
while printing a duplex job. Do not attempt to
remove the pages until the job is complete.
Do not grab paper as it temporarily comes
into the output bin. The message will
disappear when the job is finished.
Table 3-14 Control-panel messages (continued)
ENWW Tools for troubleshooting 365