5. Separate the main-drive assembly from the product.
Figure 2-200 Remove the main-drive assembly (5 of 6)
6. Release the wire harness (callout 1) from the guides, and then remove the main-drive assembly
from the product.
Reinstallation tip It might be easier to pass this harness over the edge of the assembly chassis
after the main-drive assembly is reinstalled.
Figure 2-201 Remove the main-drive assembly (6 of 6)
1
CAUTION: Be careful when you remove the assembly. The cams on the backside of the
assembly can be dislodged. If the cams become dislodged, install them on the shafts as shown in
Figure 2-202 Reinstall the main-drive assembly (1 of 7) on page 207.
The black cam must be installed on the shaft furthest away from the developing-disengagement
motor. The white cams are interchangeable.
206 Chapter 2 Removal and replacement ENWW