Remove the main-drive assembly
1. Remove eight connectors (callout 1), and then release the wire harnesses from the guides
(callout 2).
NOTE: Leave the wire harnesses with the product.
Figure 2-196 Remove the main-drive assembly (1 of 6)
1
2
2. Remove two screws (callout 1), disconnect one connector (callout 2), and then remove the
developing-disengagement motor.
NOTE: When the motor is reinstalled, make sure the motor PCA is positioned at the top of the
assembly.
Figure 2-197 Remove the main-drive assembly (2 of 6)
2
1
204 Chapter 2 Removal and replacement ENWW