Filter
Top Products
4. Verify that the cams (callout 1) align correctly.
TIP: The second cam in from the right (the white cam to the left of the black cam), should have
the second hole aligned with the hole in the sheet-metal chassis.
The third cam in from the right, should have the third hole aligned with the hole in the sheet-metal
chassis.
The fourth cam in from the right (the cam nearest the developing-disengagement motor), should
have the fourth hole aligned with the hole in the sheet-metal chassis.
If the second, third, or fourth cams do not correctly align, do the following. Hold the long drive shaft,
gently tilt the cam and gear away from the shaft to allow clearance to rotate the gear until the correct
hole in the gear aligns with the hole in the chassis.
Figure 2-205 Reinstall the main-drive assembly (4 of 7)
1
5. When the cams align correctly, they easily fit into the holes in the chassis.
Figure 2-206 Reinstall the main-drive assembly (5 of 7)
ENWW Internal assemblies 209