Filter
Top Products
Configure Printing 2-5
5. Configure the UV lamps operation by touching the “High,”
“Low,” or “Shuttered” options for the leading and trailing
lamps. Buttons will appear or disappear to present only valid
combinations (for example, you cannot set both lamps to
Shuttered).
• For standard media listed in the Media Wizard, leave the
lamp settings at their default values, then adjust as
needed.
• Faster print modes require higher lamp settings to ensure
sufficient curing.
• If the ink is not curing, increase the setting. The lamps
will gradually lose curing effectiveness, so increasing the
setting eventually may become necessary. (For infoma-
tion about UV lamp life, see “Replacing UV Lamp Bulbs”
on page 6-19.)
• If the media is wrinkling or warping from the heat of the
lamps, lower the setting.
6. Press Proceed to save the settings and return to the Front
Page, or Cancel to restore the previous print mode settings.