Filter
Top Products
2-16 Load and Print on Roll-Fed Media
OR
If the media is already configured, from the Front Page
screen of the control panel, press the Load key.
The printer displays a menu with the following options:
• New Load — loads a new media, discards previous
settings (see page 2-16).
• Restore Loaded State — loads media using the previ-
ously-used settings when rollfed media is already loaded
in the printer but the printer is not in a loaded state. This
can happen if the printer goes to sleep or is rebooted, or
if you press the Unload key on the front panel, but not
physically remove the media from the printer (see page
2-19).
Follow the procedure on the next sections that corresponds
to the load option you choose.
New Load 6. On the Select Thickness Units screen, press the option that
corresponds to the units you will use.
7. On the Enter Media Thickness screen, enter the media
thickness, or press the Esc key to use the default thickness.
8. As prompted by the control panel, remove the foam press
roller, then press the Proceed (!) key.
9. Pull the media from the roll, pull it over the foam lift roller
o
(the foam press roller
p should not be in position yet) and
lay it on the belt up to the input media roller
q.
10. On the control panel, press the upper (forward) Advance
Media arrow key to advance the media, with the vacuum
fans on.
You may need to hold the media down on the belt until the
vacuum grabs it.
• If using the takeup system, advance the media until it
hangs on exit side down to the takeup roller. Do not tape
the media to the core at this time.
• If not using the takeup system, advance the media at
least past the output media roller
r. During printing,