Filter
Top Products
Load and Print on Roll-Fed Media 2-15
Load and Print on
Roll-Fed Media
If the optional roll-fed media supply and takeup system is
installed on the printer, you can print on roll-fed media.
1. If installed, detach the rigid media input and output tables
from the printer, and set them aside.
2. If you will be using the takeup system, install the takeup
spool (see
u in Fig. 2-5).
3. Load the media centered onto the supply spool
n.
Note To prevent fingerprints from showing on printed out-
put, wear gloves while handling the media.
4. Load the supply spool onto the supply system bracket.
You can print on either side of the media by loading the
spool so the media spools off the bottom of the roll or the top
of the roll.
5. Configure the media as explained in “Configure Media” on
page 2-6. At the end of the Configure Media process, press
the Proceed (!) key on the control panel.
Fig. 2-5. Media route in the takeup system
n
o
p
q
r
s
t
u