Filter
Top Products
5 Insert the board firmly into the SIMM slot
at about a 20-degree angle. Use closest
open slot toward the back of the printer.
6 Rotate the SIMM toward the back of the
printer to about a 45-degree angle until it
clicks into the metal locking tabs. If it is
properly seated, it will not lift away from
the slot. (To remove a SIMM, you must
first release the metal locking tabs.)
7 Slide the printer controller board back
into the printer (A) and tighten the two
screws (B).
8 Reattach any cables (A) and the power
cord (B), then switch the printer ON (C)
and test the SIMM (see the following
section).
5
20
45
6
7
8
Memory/Personality SIMM Installation D-3