Filter
Top Products
Job Menu
You can change Job Menu items through your software application if you
have installed an appropriate printer driver.
Item Options Explanation
RESOLUTION 300 or 600* At 600 dpi (dots per inch), the printer might need as much as
four times more memory to format a page than it needs at
300 dpi. For most purposes, 600 dpi is recommended.
PERSONALTY AUTO*
PCL
PS
Personality
means printer language. Your printer can switch
from its standard personality, PCL, to other personalities,
such as PostScript. When PERSONALTY is set to AUTO, the
printer analyzes each print job it receives and switches
personalities automatically.
When you make another personality the default, the printer
stops switching personalities automatically unless a software
command specifically instructs it to do so. (See “Switching
Printer Languages (Personalities)” in Chapter 5.)
If you select PS as the default, you may want to set
ADV FNCTNS in the Parallel Menu to OFF.
PWRSAVE OFF, 15 MIN,
30 MIN*, 1 HR,
2 HRS, 3 HRS
Sets the amount of time the printer is idle before the fuser
shuts down. The printer automatically starts warming the
fuser when you send a print job to the printer, press a control
panel key, load or remove paper, or open the top door. (See
“Saving Energy with Power Save” in Chapter 5.)
IO TIMEOUT 5 to 300
15*
I/O timeout refers to the time, measured in seconds, that the
printer waits before ending an incomplete print job. Scrolls in
increments of 10. This setting allows you to adjust timeout for
best performance. If data from other ports appear in the
middle of your print job, increase the timeout value.
PAGEPROTCT AUTO*
ON
You will not see this item unless the error 21 PRINT OVERRUN
has occurred. (See Chapter 8, “Solving Printer Problems.”)
*Factory default.
Table 4-5 Job Menu Items
4
Understanding the Control Panel 4-9