Filter
Top Products
To Adjust Print Density
You can change the print density using the
printer’s density dial by following these steps:
Warning
The fusing assembly gets HOT. Do not
touch the fusing assembly.
1 Using both hands, open the MP Tray by
grasping the door on the front of the
printer, at the pattern of raised dots on
each side. If the MP Tray is open, remove
any paper.
2 Push up the front cover release button
and gently pull open the front cover.
3 The density dial is located at the upper
left corner of the printer. Move the dial
forward (toward you) to increase the
density or backward (away from you) to
reduce the density. The factory default is
set at the center or mid-range.
4 Using both hands, gently close the front
cover and, unless you want to use it, close
the MP Tray.
Note
It may take printing up to 20 pages for the
new print density setting to stabilize.
2
3
1
4
Special Tasks 5-13