Filter
Top Products
Cartridge-out response
The printer has two options for this menu item.
●
Select CONTINUE to allow the printer to continue printing. A REPLACE CARTRIDGE warning
message appears until the print cartridge is replaced. Printing in this mode can continue only for
a specific number of pages. After that, the printer stops printing until you replace the empty print
cartridge. This is the default setting.
●
Select STOP if you want the printer to stop printing until the empty print cartridge is replaced.
To set the cartridge-out response
1. Press Menu to open the menus.
2.
Press
to highlight CONFIGURE DEVICE, and then press .
3.
Press
to highlight SYSTEM SETUP, and then press .
4.
Press
to highlight CARTRIDGE OUT, and then press .
5.
Press
or to select the appropriate setting, and then press .
6. Press Menu to exit the menu.
Jam recovery
Use this option to configure the printer response to jams, including how the printer handles the pages
involved. AUTO is the default value.
●
AUTO: The printer automatically turns jam recovery on when sufficient memory is available.
●
ON: The printer reprints any page that is involved in a jam. Additional memory is allocated to
store the last few pages that were printed, and this might cause overall printer performance to
suffer.
●
OFF: The printer does not reprint any page that was involved in a jam. Because no memory is
used to store the most recent pages, overall printer performance might be optimized.
To set the jam-recovery response
1. Press Menu to open the menus.
2.
Press
to highlight CONFIGURE DEVICE, and then press .
3.
Press
to highlight SYSTEM SETUP, and then press .
4.
Press
to highlight JAM RECOVERY, and then press .
5.
Press
or to select the appropriate setting, and then press .
6. Press Menu to exit the menu.
46 Chapter 2 Control panel ENWW