Filter
Top Products
Memory SIMMs
Appendix C: Installing and Removing Printer Options ❖ C-9
4
Carefully push out on the locking clips to
release the SIMM.
5
Rotate the SIMM down out of position,
then lift it out.
6
Replace the controller board, sliding it
along the alignment channels. Then
hand-tighten the thumb screws.
7
Replace the power and interface cables
and power ON the printer.
After warming up for a few minutes, the
Control Panel displays the following
message:
Online
Ready
If any other message is displayed, see
Table 6.2 starting on page 6-6.
kug-appc Page 9 Thursday, March 6, 1997 4:51 PM