Filter
Top Products
Envelope Feeder
C-46 ❖ LN17 and LN17ps Printers User Guide
Removing the
Envelope Feeder
1
Power OFF the printer and disconnect both power cords and any interface cables.
2
Lift the Envelope Feeder up and out from
the printer.
Store the Envelope Feeder in its
original packaging materials, or in a
dry, dust-free place.
3
Re-attach the face plate that was removed
when the Envelope Feeder was installed.
4
Close the hinged clasp at the left side of
the Front Tray.
Close the Front Tray if not needed.
5
Reconnect the power cord and interface
cable(s) and power ON the printer.
After warming up for a few minutes, the
Control Panel displays the following
message:
Online
Ready
If any other message is displayed, see
Table 6.2 starting on page 6-6.
kug-appc Page 46 Thursday, March 6, 1997 4:51 PM