Filter
Top Products
Control Panel Messages
Chapter 6: Troubleshooting ❖ 6-11
Flushing...
The PostScript print job was cancelled from the Reset Menu and is being parsed
out and discarded.
ACTION: None.
Formatting Disk
Please Wait...
The hard disk is being partitioned and high level formatted.
ACTION: None.
Front Tray
Your application specifies “Manual” (or “Front Tray”) as the paper source so you
need to load paper in the front tray.
ACTION: The message on the bottom line of the Control Panel display advises
what paper size to load or feed.
Front Tray Empty
The front tray is empty.
ACTION: Reload the correct size of paper.
Front Tray Jam-
Remove All Paper
Paper has jammed feeding from the front tray. The message alternates with:
Open Front Cover
Remove Jam Sheet
ACTION: Remove all paper from the front tray, open the front cover and pull out
the jammed paper. Then close the front cover and reload the front
tray. See “Front Tray Jam” (page 6-27).
Fuser Failure
Service Required
The fuser assembly has failed; printing cannot resume.
ACTION: Cycle power on the printer. If you have just replaced the Fuser
Cartridge, reseat it. If the problem persists, contact your dealer or
Digital.
Hex Dump
Hex dump mode is On.
ACTION: None.
I/O Initializing
Please Wait...
The Digital Network Interface Card is being initialized.
ACTION: Wait until you see the following message before taking other actions:
Online ___
Ready
Install
Print Cartridge
The EP (print) cartridge is missing or not installed correctly.
ACTION: Reinstall the existing EP cartridge or install a new EP cartridge. If
problem continues, contact your dealer or Digital.
Table 6.2 Control Panel messages (continued)
Message
Description/Corrective Action
Table 6.2 Page 6 of 19
kug-ch06 Page 11 Thursday, March 6, 1997 4:48 PM