Filter
Top Products
Control Panel Messages
6-8 ❖ LN17 and LN17ps Printers User Guide
Disk
A hard disk error has occurred.
ACTION: Power cycle the printer. If this message reappears, power off the
printer and contact your dealer or Digital.
Disk Failure
A general failure of the hard disk has occurred.
Under this message, the following message is displayed:
Press *
ACTION: Press Enter . The printer displays the following message:
Disk Not In Use
Printing resumes without use of the hard disk.
Disk Format Bad
The hard disk high level format (FAT tables) cannot be understood. This is NOT
because a new disk has been installed.
ACTION: Either initialize the disk format procedure by pressing Up , or abort
the procedure by pressing Down .
This message flashes alternately with the two-line message:
Press ↑ to init
Press ↓ to Abort
Disk Not In Use
A failure of the hard disk has occurred and been acknowledged. Printing resumes
without use of the hard disk.
ACTION: Make sure the hard disk is properly seated on the controller board. If
the problem remains, contact your dealer or Digital.
Disk Read Error
The printer cannot read data from the hard disk.
ACTION: Try powering the printer OFF then ON again. Make sure the hard disk
is properly seated on the controller board. If the problem remains,
contact your dealer or Digital.
Disk Write Error
The printer cannot write data to the hard disk.
ACTION: Press Enter . The printer will mark the disk sector as bad and retry
the write operation at another location on the disk. Make sure the
hard disk is properly seated on the controller board. If the problem
remains, contact your dealer or Digital.
Table 6.2 Control Panel messages (continued)
Message
Description/Corrective Action
Table 6.2 Page 3 of 19
kug-ch06 Page 8 Thursday, March 6, 1997 4:48 PM