Filter
Top Products
Installing and Removing Printer Options
C-10 ❖ LN17 and LN17ps Printers User Guide
PostScript
SIMM
This section contains two sets of instructions:
• “Installing the PostScript SIMM” (below)
• “Removing the PostScript SIMM” (page C-13)
Installing the
PostScript SIMM
Caution
SIMMs and controller boards are sensitive to static electricity.
Before installing a SIMM, discharge static electricity from
your body by touching something metal, such as the metal
back plate on any device plugged into a grounded power
source. If you walk around before finishing the installation,
again discharge any static electricity.
Never remove the printer controller board while the printer is
plugged in.
1
Power OFF the printer and disconnect the power cord and any interface cables.
2
Loosen the thumb screws and pull out the
controller board.
3
Place the controller board on a ream of
paper.
kug-appc Page 10 Thursday, March 6, 1997 4:51 PM